This time around I have decided to construct the rear apron on the car rather than welding it together on the bench. This will allow me to ensure the decklid fits as it all goes together. I have the apron tacked to the car and the H pattern tacked into the apron in this picture. I have already set the decklid in place and everything fits perfectly.
Now the finish welding is almost done. The first pass has been finished and ground down. All that is left is to fill all the pinholes as well as the 2 slits I had to cut to make the apron lay flat. Next up will be to weld the decklid and engine seal retainers in place.
No comments:
Post a Comment