After 1457 days the body is finally back on the pan for good! It has taken a ton of work over the past couple weeks but it's starting to look like a car again. I had to cut the flange off the header and weld it back on correctly so the muffler fit right, install the engine seals, lower the rear end, align the front the best I could and wrap up the wiring. At this point the front and rear has been bolted down but the heater channel bolts are not in place yet.
Friday, March 16, 2012
And the 2 Became 1
After 1457 days the body is finally back on the pan for good! It has taken a ton of work over the past couple weeks but it's starting to look like a car again. I had to cut the flange off the header and weld it back on correctly so the muffler fit right, install the engine seals, lower the rear end, align the front the best I could and wrap up the wiring. At this point the front and rear has been bolted down but the heater channel bolts are not in place yet.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment